Return to item
|
SPECIFICATIONS
|
RMX 850 | RMX 1450 | RMX 1850HD | RMX 2450 |
|---|---|---|---|---|
| STEREO MODE (Both Channels Driven) | ||||
| 8 ohms FTC 20 Hz - 20 kHz, 0.1% THD EIA 1 kHz, 0.1% THD |
185 W 200 W |
260 W 280 W |
350 W 360 W |
450 W 500 W |
| 4 ohms FTC 20 Hz - 20 kHz, 0.1% THD EIA 1 kHz, 0.1% THD |
280 W 300 W |
400 W 450 W |
550 W 600 W |
650 W 750 W |
| 2 ohms EIA 1 kHz, 1% THD |
430 W |
700 W |
900 W |
1200 W |
| BRIDGE MONO MODE | ||||
| 8 ohms FTC 20 Hz - 20 kHz, 0.1% THD EIA 1 kHz, 0.1% THD |
530 W 600 W |
800 W 900 W |
1100 W 1200 W |
1300 W 1500 W |
| 4 ohms EIA 1 kHz, 1% THD |
830 W |
1400 W |
1800 W |
2400 W |
| Signal to Noise, 20 Hz-20 kHz | 100 dB | 100 dB | 100 dB | 100 dB |
| Distortion (SMPTE-IM) | Less than 0.01% | Less than 0.01% | Less than 0.02% | Less than 0.02% |
| Input Sensitivity @ 8 ohms | 1.15V (+3.4 dBu) | 1.15V (+3.4 dBu) | 1.16V (+3.5 dBu) | 1.23V (+4.0 dBu) |
| Voltage Gain | 31.6x (30 dB) | 40x (32 dB) | 46x (33 dB) | 50x (34 dB) |
| Output Circuitry | AB | AB | Class H | Class H |
| Power Requirements 1/8 power pink noise at 4 ohms * |
5A | 6A | 6A | 7A |
| ALL MODELS | ||||
| Distortion (Typical) 20 Hz - 20 kHz: 10 dB below rated power 1.0 kHz and below: full rated power |
Less than 0.03% THD, 4 and 8 ohms Less than 0.03% THD, 4 and 8 ohms |
|||
| Frequency Response | 20 Hz-20 kHz, ±1 dB -3 dB points: 5 Hz - 50 kHz |
|||
| Damping Factor, 1 kHz and below | Greater than 300 at 8 ohms | |||
| Input Impedance | 10k ohms unbalanced, 20k ohms balanced | |||
| Input Clipping | 10 Vrms (+22 dB) | |||
| Cooling | Continuously variable-speed fan, rear-to-front air flow | |||
| Connectors, each channel | Input: Active balanced; barrier strip, XLR and 1/4"
(6.3mm) TRS tip and XLR (pin 2 positive) Output: touch-proof binding posts and Neutrik® Speakon® |
|||
| Controls | Front: AC switch, Ch. 1 and Ch. 2 gain knobs Rear: 10-position DIP switch |
|||
| Indicators | Power-On: Green LED Signal: Yellow LED (1 per channel) Clip: Red LED (1 per channel) |
|||
| Amplifier Protection | Stable into reactive or mismatched loads | |||
| Load Protection | On/off muting, AC coupling (850, 1450), triac crowbar (1850HD, 2450, on each channel) | |||
| Power Requirements | 100, 120, 230 VAC, 50-60 Hz | |||
| Dimensions | 19" (48.3 cm) rack mounting, 3.5" (8.9 cm) tall (2 RU),
15.9" (40 cm) deep (rack mounting to rear support ears) |
|||
| Weight | 35 lbs (15.9 kg) net | 40 lbs (18.2 kg) net | 44.5 lbs (20.2 kg) net | 44.5 lbs (20.2 kg) net |
All Specification Subject to Change Without Notice.
Speakon is a trademark of Neutrik
